サスペンション組み立てマニュアル(旧ページ)

You may want to jack the body up off the ground using the floor and car jacks on both ends, then pick it up with the tractor forklift.
I would advise picking up the chassis from the front if you can, as it tends to tip off as it gets weighed down by installing new components. Otherwise just be mindful as you go.
Move the Motor Hoist to the Engine Bay, Lower it carefully and when it is in the 3 correct position bolts should appear at the Motor mounts for you to tighten with a 11mm spanner.
Subframe-4x10m
Steering Rack-4x9mm
Steering Column-2x8mm
Wishbones-2x10mm each
Spindles-1x12mm each
Steering Rods-1x12mm each (Wait to tighten until Struts are installed.)
Disc Brakes-1x14mm each (14mm Bolt Shared with Halfshafts, install Halfshafts before you tighten.)
Halfshafts-3x9mm, 1x14mm each (Bolt Shared with Disc Brake.)
Struts-4x9mm,3x10mm, 1x12mm (12mm Bolt Shared with Steering Rods.)
Steering Rod Adjust-1x14mm each (Eyeball it the best you can for now.)
Trailing Arms-2x12mm each
Coil Springs
Shock absorbers-1x12mm,2x6mm each
Drum Brakes-1x14mm each
Wheels-4x13mm each(You may want to pick the chassis up with the forklift from the side now as it tends to slide around otherwise.)
Hubcaps
Spark Plugs (No spanner required, but must be tightened.)
Battery
Electronics(to body)-2x8mm
Fuel strainer-1x8mm
Radiator-4x7mm
Radiator Hoses
Oil Filter (Same as Spark Plugs, must be tightened.)
Clutch Master Cylinder-1x9mm, 2x8mm
Brake Master Cylinder-1x9mm, 2x8mm
Clutch Line-2x7mm
Brake Line-8x7mm
Brake line (at wheel, one each)-4x7mm
Steering Wheel-1x10mm
Fuel Tank-7x11mm,1x12mm (at fuel line)
Gear Stick-3x6mm
Gear Linkage-3x5mm
Dash-2x10mm
RPM Gauge (or Clock if you prefer, attaches to Dashboard Meters)-2x7mm
Dashboard Meters-2x6mm
Radio
Headlights-2x7mm each
Grille-2x6mm
Bumpers-2x8mm each
Driver/Passenger Seat-4x9mm each
Hand Brake-4x8mm,1x5mm
Exhaust Pipe-3x7mm (This can be a pain, you will need to take the chassis off the forklift for this. Jack up one side of the car with the floor jack, attach the Exhaust Pipe near the handbrake. Two bolts at the header, one in the rear.)
Exhaust Muffler-1x7mm
Fenders-5x5mm each
Doors-4x10mm each
Fuel Tank Pipe
Boot Lid-4x6mm
Rear Lenses
Back Panel or Subwoofer Panel
Hood-4x6mm (You'll have to remove the Air Filter to install this)

Fill up the engine fluids by unscrewing the caps on the engine components, then holding the containers upside down over them until a green bar appears (The fluid containers don't have caps). The clutch cylinder uses brake fluid. The gas can, coolant, brake fluid and motor oil aren't infinite. Tighten the caps again when you are finished. You can also pee in your radiator if you want. NOTE: Buy at least 3 bottles of brake fluid as it tends to run out quickly.